300MW等级锅炉变工况低负荷稳燃能力数值模拟与预测

采用数值模拟软测量技术,在保证锅炉燃烧稳定和炉内温度较高水平的条件下,预测300 MW等级锅炉在实际运行中可降低到25%负荷稳定燃烧,并经过现场低负荷稳燃实验对结果进行验证。针对一次风速调整、磨煤机投运方式调整和配风方式及运行氧量调整三种方式对低负荷稳燃能力的影响进行分析,结果表明:在降负荷过程中调平一次风速偏差并适当降低一次风速,投运相邻层燃烧器,关小周界风,适当降低二次风量的同时适当降低运行氧量有利于提高低负荷稳燃特性。     

Interactions between hydrogen and the (112¯1) twin boundary in hexagonal close-packed titanium

In hexagonal close-packed titanium, the interactions between the $\left(11\overline{2}1\right)$ twin boundary (TB) and hydrogen solute atoms with several different concentrations are investigated by using first-principles calculations. The preferential occupation sites of hydrogen atoms in the $\left(11\overline{2}1\right)$ TB region are searched and vary with the amount of hydrogen. Both the shift of the TB and the diffusion of hydrogen atoms, as well as the mutual effect on the movement of each other, are studied. The energy barriers of the TB shift increase with the hydrogen concentration. Additionally, the simulated tensile tests are applied for several systems with co-existing $\left(11\overline{2}1\right)$ TB and hydrogen atoms, and different geometry transformation behaviors at different hydrogen concentrations are found under the increasing tensile strain.     

机翼极限环颤振的CFD/CSD全隐式紧耦合方法

针对轴承振动实时状态监控的需要，从符号动力学角度提出了符号聚合近似与Lempel-ziv复杂度（SAX-LZC）融合的振动监控参数。首先，以Logistic映射和Duffing方程为对象，从理论角度验证了SAX-LZC对动力学结构表征的准确性，并验证了该指标的抗噪能力和计算效率；其次，将SAX-LZC指标与信息熵、样本熵、多分段Lempel-ziv复杂度等动力学参数性能进行了综合对比；最后，从实验角度对轴承早期微弱异常进行了监测，并对轴承典型故障进行了特征提取。理论研究结果表明，SAX-LZC具有动力学结构表征准确、抗噪能力好、计算高效简洁等优点，克服了常规动力学参数工程应用能力弱的问题。实验研究结果表明，SAX-LZC对早期微弱异常有准确的监测，对不同种类故障具有较好的区分度，弥补了时域和频域对轴承微弱故障表征能力不足的缺陷，是一种轴承振动实时状态监控与故障特征提取的有效参数。     

A variational approach for free vibrating micro-rods with classical and non-classical new boundary conditions accounting for nonlocal strengthening and temperature effects

Abstract

Transverse vibration of a circular cross sectional micro-rod subjected to a new kind of boundary constraints with elastic torsional springs is presented based on nonlocal elasticity. A nonlocal strengthening beam model is utilized and the effect of temperature changing is taken into consideration. The variational method and Hamilton’s principle are applied to derive the governing equation of motion and corresponding boundary conditions. A higher-order partial differential equation that is a typical characteristic of nonlocal strengthening model is developed, and the boundary conditions contain not only classical conditions but also non-classical higher-order conditions. Unlike previous studies which were only concerned with some conventional boundary constraints, we consider more general boundary conditions named elastic torsional spring supports. Such boundary conditions are between the simply supported and clamped ones, and they are closer to the actual constraints of existing engineering structures. Natural frequencies of micro-rods with new boundary constraints are determined via an eigenvalue method and compared with other results in the literature. It is shown that the nonlocal scale factor, thermal parameter, rigidity parameter and torsional spring coefficient play significant roles in free vibration of micro-rods. The research can provide a reference for a large class of boundary conditions ranging from simply supported to clamped micro-rods.     

边角煤短壁机械化充填开采技术研究

根据我国煤矿的地质条件,将传统房柱式采煤提升为安全高效的短壁机械化采煤方法,并与充填技术相结合,针对充填技术特点合理布置采区巷道,充分利用充填物料凝固后的支撑强度,控制地表下沉和岩层移动,对煤柱、不规则块段、地质构造较复杂的煤层以及"三下"压煤等边角煤开采等提供了切实可行的技术途径,提高了煤炭资源回收率和开采效率。     

析湿工况下翅片管式换热器表面粉尘沉积过程的数值模型

空调器采用翅片管式换热器作为蒸发器，在制冷工况下换热器表面发生析湿及粉尘沉积，导致性能衰减。建立湿翅片表面粉尘颗粒物沉积过程的数学模型，模拟冷凝水捕集颗粒物以及湿积灰层黏附颗粒物的过程。被冷凝水捕集的颗粒物数量等于运动轨迹与水表面轮廓会出现相交的入射颗粒物的数量；后续的入射颗粒物与湿积灰层碰撞时，部分入射颗粒物会发生沉积且部分被碰撞的已沉积湿颗粒物会发生移除，这两部分的颗粒物数量相减即为被湿积灰层黏附的颗粒物数量。模拟与实验结果的对比表明，预测的湿积灰层形状与实验照片的吻合度较好，预测的单位面积颗粒物沉积质量与91%的实验数据之间的误差在±20%之间，平均误差为11.8%。     

基于涡动相关法的沉积物-水界面氧通量与水动力条件响应关系

沉积物-水界面是物质参与环境地球化学循环和生物耦合的"热区",水动力条件是沉积物-水界面物质交换的关键影响因素。溶解氧作为常用的水质评价指标,对调节生物化学进程有重要作用,因此本文采用涡动相关法这种非侵入式通量测量技术开展室内试验研究,探究沉积物-水界面氧通量与水动力条件的响应关系。结果表明:随着水体紊动增加(采用Batchelor尺度表征),扩散边界层厚度减小,氧通量增大。分析室内试验和相关研究中水动力条件、扩散边界层厚度及氧通量的关系,发现扩散边界层厚度与Batchelor尺度呈正相关关系,拟合结果表明可以用Batchelor尺度近似表示扩散边界层厚度;氧通量与扩散边界层厚度呈负相关关系,且当扩散边界层厚度小于0.5 mm时,扩散边界层厚度变化对氧通量影响更强烈,当厚度大于0.5 mm后,氧通量基本保持稳定。     

低阶煤热解条件对高炉喷吹半焦燃烧性能及动力学特性的影响

采用热重分析法研究了不同热解条件下半焦的燃烧性能和动力学特征，利用Ozawa法求取动力学参数。结果表明，热解温度越低、保温时间越短时，半焦的燃烧性能越好；热解升温速率对半焦燃烧过程的反应程度影响不大；粒度越大，燃烧性能差异性越明显。热解温度对半焦燃烧性能影响较大，550℃是本研究中制备高燃烧反应性半焦的适宜热解温度。两种不同粒度原煤制得的半焦均随转化率增大，活化能减小。1~3 mm原煤在热解温度为550℃时所得半焦在燃烧过程中符合反应级数模型，化学反应为限制性环节，反应最概然机理函数为f(α)=(1–α)2。     

Structure,properties, and applications of polyacrylonitrile/carbon nanotube (CNT) fibers at low CNT loading

Bi-component, polyacrylonitrile (PAN)/carbon nanotube (CNT) fibers were processed, at different core-sheath area ratios, by gel spinning. A percolated CNT network at 10 wt% CNT in the sheath enhanced electrical conductivity as compared to the neat PAN fiber, while PAN polymer in the core contributed to the good mechanical properties. Fibers with relatively thin sheath allowed overall CNT loading as low as 3.7 wt% to be made with good electrical conductivity, and PAN stabilization by Joule heating was demonstrated. Such fibers with combined good mechanical properties and electrical conductivity can also potentially be used for electrical heating of fabrics, for making smart textiles, and for electromagnetic interference shielding.     

具有高耐蚀性和导电性的掺Cr类金刚石非晶碳的化学式解析

Cr掺杂的类金刚石非晶碳具有良好的导电性和耐腐蚀性,这对于燃料电池金属双极板涂层改性特别重要。使用团簇加连接原子模型对其非晶结构进行了详细解析,在该模型中,良好的玻璃形成材料由覆盖特征性最近邻团簇加上几个下一壳层原子的结构单元来表述。根据文献,在Cr掺杂的类金刚石非晶碳中占优势的团簇是Cr中心和C壳层的[Cr-C4]四面体团簇,然后将该团簇与适当的连接原子匹配,以满足电子轨道饱和原理。由此推导出了两个最优组成式,即[Cr-C4]CrC3(22.2%Cr)和[Cr-C4]Cr3C2(40%Cr),它们显示出良好的非晶态结构稳定性。实验结果显示,所提出的这两组化学组成的涂层材料兼具低电阻率(低至10-4Ω·cm)和优异的耐腐蚀性(腐蚀电流密度~10^-2μA/cm^2)。在sp2键含量和渗流理论的框架内讨论了导电和耐蚀的协同行为。这项工作验证了团簇加连接原子模型在具有高耐腐蚀性和高导电性的涂层材料成分设计中的可行性。